Daily Cleaning (Before startup / After shutdown)
Key Tasks: Remove metal slag from the worktable and dust from the machine's exterior; visually inspect and wipe the cutting head's protective lens and nozzle surface to remove loose dust.
Additional Actions: Clean the gas inlet nozzle to prevent clumping and blockages caused by fumes and dust; wipe dust off exposed sections of the Z-axis guide rails to prevent dust from entering the slide blocks.
Weekly Cleaning
Key Tasks: Thoroughly remove accumulated dust from the dust collection box and clean or replace the primary filter element; wipe dust from guide rails and gear racks using a lint-free cloth dampened with anti-rust oil, and apply a small amount of gear grease.
Additional Actions: After disconnecting the power, use a low-pressure air gun to blow dust off the cooling fans and circuit boards inside the electrical cabinet to prevent overheating caused by dust accumulation.
Monthly Cleaning
Key Tasks: Replace the circulating purified water in the chiller and thoroughly clean the inner walls of the chiller's water tank; perform a deep clean of the focusing lens and reflecting mirrors; drain accumulated water from the gas line filter.
Additional Actions: Remove dust from the cooling fins of the servo motors; inspect the grooves of the synchronous belt pulleys for metal debris and wipe them clean.
